Store Front  »  Accumulating Conveyor  »  Model 190ACC  »  Specifications

Model 190-ACC Horizontal Power Conveyor (Accumulating Type)

Model 190-ACC

Conveyor sections are easily coupled together at either end to make up to 100 ft. long units. Drive is usually located near center of conveyor.

OVERALL VIEW

Overall View

SECTION "X-X"
Section "X-X"
SECTION "Y-Y"
Section "Y-Y"

BED - Roller bed with 1.9 in. dia. roller x 16 ga. galvanized tube spaced every 3 in. and 1.9 in. dia. pressure rollers x 16 ga. galvanized tube spaced every 6 in. Mounted in 6-1/2 in. x 12 ga. powder painted formed steel channel frame bolted together with butt couplings.

CROSS BRACING - Rods with turnbuckles are fastened to underside of bed to provide proper alignment of bed rollers and insure correct product tracking. Supplied on every other section 30 ft. bed lengths and over.

DRIVE - Mounted underneath, placed near center of conveyor.

DRIVE BELT - Endless B-section aramid core V-Belt drives each section of conveyor.

RETURN TAKE-UP SHEAVE - 3-1/4 in. dia. x 1/2 bore flat idler has seven position adjustment to maintain proper V-belt tension.

BEARINGS - Tread & pressure rollers have pre-lubricated ball bearings. Flange and pillow block bearings are sealed, pre-lubricated with eccentric lock collar.

SPEED REDUCTION - Sealed worm gear C-Face speed reducer. No. 50 roller chain to drive shaft.

MOTOR - 1/2 HP - 230/460V - 3 Ph. 60 Hz. Totally Enclosed C-Face.

CONVEYING SPEED - Constant 65 FPM.

CAPACITY - Maximum load per linear foot of conveyor 150 lbs. NOT TO EXCEED capacity in chart.

FLOOR SUPPORTS - Now supplied as optional equipment.

How It Works!

The driving of the tread rollers on the HYTROL minimum pressure conveyor is accomplished with the top surface of a standard section endless V belt. The strength and wear qualities of the tread rollers and this belt have been thoroughly tested for continuous duty.

To maintain the driving of the tread roller, the pressure roller is mounted in spring adjusted carriers (See Photo) which sense the required driving friction regardless of the length of accumulated load. This pressure can be maintained constantly to give a 2% minimum back pressure in either a forward or reverse direction.

In the event of extreme changes in unit load (weight of box or package), convenient knurled thumb adjusting nuts can be turned to accept this heavier load.

This method eliminates the need for selecting proper tension spring holes in trigger mechanisms or jogging cleats on driving belt and eccentric (off center) tread rollers.

By maintaining a constant minimum pressure on the tread rollers, long loads may be conveyed, accumulated or stopped on the conveyor at any point using very little motor horsepower and giving practically no pressure between boxes or packages.

 

LOAD CAPACITY CHART @ 65 FPM
HP OVERALL FRAME WIDTHS OVERALL FRAME WIDTHS OVERALL FRAME WIDTHS
16" TO 22" 24" TO 30" 34" TO 42"
TOTAL LOAD (LBS.) TOTAL LOAD (LBS.) TOTAL LOAD (LBS.)
UP TO 100' UP TO 100' UP TO 100'
1/2 1000 800 500
1 2400 2200 2000

 

 Model 190-ACC