BELT-Ultimate 140 BOS-Nitrile, impregnated belt with one side brushed.
BED-4 in. deep x 12 ga. formed steel slider bed with 2-1/2 in. deep guards, powder painted. Standard 5 ft. & 10 ft. long sections bolt together with splice plates.
END DRIVE-Located on discharge end of conveyor, chain guard on left hand side.
DRIVE PULLEY-4 in. dia. with 1 in. dia. shaft at bearings or 8 in. dia. with 1-3/16 in. dia. shaft at bearings, machine crowned and fully lagged.
TAIL PULLEY-4 in. dia. with 1 in. dia. shaft at bearings, machine crowned.
SNUB IDLER-Adjustable 2-1/8 in. dia. pre-lubricated ball bearings. Guards included.
RETURN IDLER-Adjustable 1.9 in. dia. pre-lubricated ball bearings.
TAKE-UP-Take-ups at tail pulley. Provides 4 in. of belt take-up.
BEARINGS-Sealed, pre-lubricated ball bearings, self-aligning, ball bearings on drive and tail pulleys.
SPEED REDUCTION-Sealed worm gear C-Face speed reducer. No. 50 roller chain to drive pulley.
MOTOR-1/2 HP-230/460V-3 Ph.-60 Hz. Totally Enclosed C-Face.
BELT SPEED-Constant 65 FPM.
CAPACITY-Maximum load per linear foot of conveyor 75 lbs. NOT TO EXCEED capacity in charts.
FLOOR SUPPORTS-Now supplied as optional equipment.
Product literature and information provided by Hytrol.
All material contained in this site is © 2000 -