BELT–Ultimate 140 BOS–Nitrile, impregnated belt with one side brushed.
BED–4 in. deep x 12 ga. formed steel slider bed- powder painted. Standard 5 ft. & 10 ft. long sections bolt together with splice plates.
END DRIVE–Located on discharge end of conveyor, chain guard on left hand side.
DRIVE PULLEY–4 in. dia. with 1 in. dia. shaft at bearings or 8 in. dia. with 1-3/16 in. dia. shaft at bearings, machine crowned and fully lagged.
TAIL PULLEY–4 in. dia. with 1 in. dia. shaft at bearings, machine crowned.
SNUB IDLER–Adjustable 2-1/8 in. dia. for 4 in. pulley–2-1/2 in. dia. for 8 in. pulley. Pre-lubricated ball bearings. Guards included.
RETURN IDLER–Adjustable 1.9 in. dia. pre-lubricated ball bearings.
TAKE-UP–Take-ups at tail pulley. Provides 4 in. of belt take-up.
BEARINGS–Sealed, pre-lubricated, self-aligning, ball bearings on drive and tail pulleys.
SPEED REDUCTION–Sealed worm gear C-Face speed reducer. No. 50 roller chain to drive pulley.
MOTOR–1/2 HP–230/460V–3 Ph.–60 Hz. Totally Enclosed C-Face.
BELT SPEED–Constant 65 FPM.
CAPACITY–Maximum load per linear foot of conveyor 75 lbs. NOT TO EXCEED capacity in charts.
FLOOR SUPPORTS–Now supplied as optional equipment
Product literature and information provided by Hytrol.
All material contained in this site is © 2000 -